DESIGNATION:
A/D - preceded by car number.
B/D - preceded by car number.

If there is any area of these rules which needs clarification, please contact Club (.400) Technical Director by e-mail at tech@club400.8m.com.

• BODY: All bodies must be 1/24th or 1/25th scale. All styrene bodies must be kit based model only. Resin cast bodies allowed. Vacuum formed styrene or lexan not allowed. No body modifications allowed. Dragster must have "skirts" if included in model kit.

•  

• INDUCTION SYSTEM: Must run full plastic motor from model kit, bottom can be cleared for clearance.

•  

• WEIGHT: 95 grams minimum weight.

•  

• REAR/WING: "Top Fuel style wings mandatory. Styrene, resin allowed. Wing must be 3-1/4" in height plus or minus 1/4" from bottom of chassis.

•  

• CHASSIS: Unlimited; Motor must be mounted in an inline configuration; ball bearings allowed.

•  

• FRONTWHEELS/TIRES: Required; 1/2" minimum diameter.

•  

• REARWHEELS/TIRES: Minimum diameter 1 -3/16" (1.185in.). Minimum tire tread width fully contacting track surface, 1/2" (0.500in.)

•  

• WHEELIEBARS/WHEELS: Permitted; Total length cannot exceed 5" from centerline of rear axle to centerline of wheelie wheels.

•  

• MOTOR:

  A/FC - Factory tagged Group 20, ball bearing permitted.
  B/FC - Factory tagged Group 12,non ball bearing.