Funny Car (Fuel and Alcohol)!

SECTION 4

DESIGNATION:
A/FC - preceded by car number.
B/FC - preceded by car number.


If there is any area of these rules which needs clarification, please contact Club (.400) Technical Director by e-mail at tech@club400.8m.com.

 

 

  • BODY: Any year funny car body allowed. All styrene bodies must be of a kit based model only. Resin cast bodies allowed. Open holes in front or rear fenders for tire clearance not allowed. Front and rear wheel bubbles allowed. Front wheel bubbles may not be any taller than 1/4", measured from the top of the fender to the top of the wheel bubble. Top may be chopped. Complete removal of top prohibited. Body must retain the full taillight panel. Body width cannot be less than 2" at any point.
  •  

  • INDUCTION SYSTEM: Must have one of the following positioned forward of the driver's compartment: - Full top hat; styrene, resin or metal allowed. - Blower with "8-port injector injector; styrene, resin or metal allowed. - Injector stacks; styrene, resin, or metal allowed.
    Top hat, blower or Injectors must be a separate unit; cannot be molded or cast into body. Full top hat: Entire unit must protrude from top body surface. Blower with " 8-port" Injector: 1/4 of blower case must be above top body surface. Injector stacks: Must protrude a minimum of 1/4", measured from top of body surface to top of stacks.
  •  

  • WEIGHT: 110 grams minimum weight.
  •  

  • SPOILERS/REAR WINGS:Permitted; Styrene, resin, or lexan only. "Top fuel" style wings prohibited. Wings cannot be longer than 1", measured from the farthest point of the rear main body to the farthest point of the wing. Cannot be wider than the widest point of the body. No roof mounted spoilers. Front spoiler or diaplane may be used. Must not be longer than 1/4", measured from the main body to the farthest point of spoiler or diaplane.
  •  

  • CHASSIS: Unlimited; Motor must be mounted in an inline configuration; ball bearings allowed.
  •  

  • FRONTWHEELS/TIRES: Required; 3/4" minimum diameter.
  •  

  • REARWHEELS/TIRES: Minimum diameter 1 -3/16" (1.185in.). Minimum tire tread width fully contacting track surface, 1/2" (0.500in.)
  •  

  • WHEELIEBARS/WHEELS: Permitted; Total length cannot exceed 5" from centerline of rear axle to centerline of wheelie wheels.
  •  

  • MOTOR:

    A/FC - Factory tagged Group 20, ball bearing permitted.
    B/FC - Factory tagged Group 12,non ball bearing.

CLUB (.400) on Twitter

Badge

Loading…

© 2012   Created by CLUB (.400).

Badges  |  Report an Issue  |  Terms of Service